Polyester Resin

Fill deeper damage like holes in surfaces of steel, aluminium, wood, concrete and polyester on your car in combination with a glass fibre mat and glass fibre fleece with MOTIP 2-component Polyester Resin. The resin is suitable for creating objects for which a mould is required. Polyester Resin is elastic and resistant to chemicals and the weather. MOTIP Polyester Resin has excellent adhesion and is after hardening only mechanically sandable.

  • yellow
  • flat mat
  • 2 volumes
    • 250 G
    • 1000 G

Where to buy


  • Elastic
  • Resistant to chemicals and weather influences
  • Excellent adhesion
  • Only mechanically sandable

Usage instructions

Before use, carefully read the directions on the packaging and act accordingly.

Processing temperature 15 – 25°C.

The surface should be clean, dry and free of grease. Remove loose old lacquer and rust and sand the surface.

Cut the fibreglass mat in the correct size, with a small overlap. Mix the required amount of polyester resin with the harder

Smear the edges of the hole to be filled with polyester resin and apply the fibreglass mat.

Smear the mat with polyester resin, starting at the edge.

Then apply the fibreglass fleeze and smear with polyester resin. Depending on the damage, this procedure can be repeated.

After hardening, only mechanically sandable. Sand and when desired apply a fine putty.

The drying time depends on the ambient temperature.

After use, directly clean the tools used. Do not store the surplus material, mixed with harder, in the can.



250 G
Flat mat
Art. nr. 000071
EAN 8711347000715


1000 G
Flat mat
Art. nr. 000072
EAN 8711347000722

* colours may differ from the preview above.